Ring-board crank: Approximated 2.5 × 21mm Logumum
| 商品情報 | 価格(税込) | 在庫 | 購入・お気に入り | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
¥308 | 〇 |
|
A ring stand with a flat, thin bar.
This is an original design from Kiwa Seisakusho. Please use adhesive to attach the parts. You can attach a continuous claw chain, design chain continuous claw pearl, resin pearl three quarter single hole, etc. to the bar. The size adjustment notch is on the bar side and can be adjusted by about ±2 to match the size of your fingers. Excel Epo is recommended as the adhesive.
*Please apply pressure slowly when adjusting the size. Also, please be careful not to repeatedly adjust the size or forcefully bend or stretch it as this may cause damage or peeling of the plating.
This is an original design from Kiwa Seisakusho. Please use adhesive to attach the parts. You can attach a continuous claw chain, design chain continuous claw pearl, resin pearl three quarter single hole, etc. to the bar. The size adjustment notch is on the bar side and can be adjusted by about ±2 to match the size of your fingers. Excel Epo is recommended as the adhesive.
*Please apply pressure slowly when adjusting the size. Also, please be careful not to repeatedly adjust the size or forcefully bend or stretch it as this may cause damage or peeling of the plating.
詳細情報
素材： 真鍮
対応パーツ
* Please purchase the size and number of the recommended items in order to purchase the required number of items.
The chain-to-nail chain (#101. 2.4mm), #110 (approximately 3.0mm), #130 (approximately 4.0mm), #170 (approximately 6.14mm)
Design chain linkage: pearl 2.5mm, 3mm
Slip-pearl slimy: One-hole, 6 mm, 8mm
Bezel #1088 PP24 (3mm) retained for #1028/#1088, PP31 (4mm), SS19 (4.5mm), SS24 (5.5mm), SS29 (6mm)
